BACHIN PRODUCT
BACHIN CONTROLLER
OFFICIAL SOFTWARE
OTHER SOFTWARE
Free Study Tutorial
Artwork for share

Bachin Articles


Engraver Master Tutorial/User Guid--Upgraded

2019-12-26 11:41:29

The Engraver Master was successfully upgraded recently,the engraving speed faster than before。

Download Engraver Master:

http://www.bachinmaker.com/update/litefire/setup.exe

Directly to generate the tool path and no need to trans-code. The engraving speed and the laser power is adjustable. There are more function like :change the size of the picture, enter text, import the NC file or dxf file. The file format that can be imported is:jpg,jpeg,png,dxf,g-code(NC file),and so on.

Here are the user guide for Engraver Master:

step 1. Installation

After installed, you will find an icon Named Engraver Master on computer desktop and the Start Menu. Double click the icon to start :

step 2. Software connected Interface of the Engraver Master:

Connection succeeded:

Connection failed:

Reasons for failure to connect:

1>If connection failed ,check the Device Manager of computer,find USB-SERIAL CH340 Port Device.

If there is an exclamation point on the device,it means the installation failed .

you should delete the icon ,and install again. Sometimes the software install succeeded but

can not connected to the machine , restart the computer.

2>The installation is no problem,but can not connect the machine, you should check the USB cable

or your USB port of the computer, change a USB cable or change a USB port.

3>Exclude the above reasons,Check the NANO which is on the control board

(the blue module connected to the USB cable) ,when there is a small light kept flashing,

maybe the firmware was missing,update the firmware as follow:

4>If the firmware is update and still can not connected , basically, it can be judged

that NANO has been damaged. Change a new one.

Software anatomy

NC Sender is the most common mode of engraving,it can satisfy most of the engraving needs,fast and Very good effect.

Here are the details.

Load NC file: load NC file (g-code file);

load CAD DXF filetips: Some versions of the file are not compatible, When you save DXF files,

select version: AutoCAD 2000, and the unit is mm).

Start /speed: Repeats(Repeated several times when used for cutting);

Speed(to adjust the speed); test size: test the size before start,for positioning).

Create image Nc file: load picture from computer,adjust the details and size.

Select the mode that you like. Look at the difference:

Create text Nc file: enter the text and select one of the font ,setting the char height

and line height, then create. Outline is just like the cutting mode .

** Let's do some exercises**

Load picture:jpe,jpeg,png

step 1.Load a picture :

step 2.Next:

Step 3.Set the size:46,click on ‘OK’.

Device Setting Tips: Different laser module requirements of different device settings.

the speed of 500mw laser should set :900-1500,and 1000-1600mw set 1200-2000, 2500-5500mw set 1600-3000.

If you want to cut something , the speed should setting more slower.

when the settings' done, click on Test the Size and Start.

DONE!!

Load NC file or G-code file

about how to create an NC file ,tutorial: http://bachinmaker.com/wiki/doku.php?id=create_nc_file

Device Setting Tips: Different laser module requirements of different device settings.

the speed of 500mw laser should set :900-1500,and 1000-1600mw set 1200-2000, 2500-5500mw set 1600-3000.

If you want to cut something , the speed should setting more slower.

when the settings' done, click on Test the Size and Start.

Support Information:

e-mail:support@bachinmaker.com

HELPs